All projects

What it is

The CC1101 is a low-cost sub-GHz transceiver from Texas Instruments. It handles the radio part of a link: modulation and demodulation, a packet engine, a small FIFO and an SPI control interface. It is not a microcontroller, so it does not run your application or decide what a payload means.

CC1101_DRIVER is an ESP-IDF C driver for that chip on an ESP32-S3. It configures the radio, sends and receives frames, and can switch between framed packets and a raw demodulator capture.

What you can use it for

  • Read simple 315, 433 or 868 MHz remotes, buttons, door and window contacts, weather stations and utility sensors.
  • Build a private low-power sensor link where Wi-Fi or Bluetooth range and power draw do not fit.
  • Inspect an unfamiliar sub-GHz signal on a bench you control and look at its timing and encoding.
  • Check, as part of an authorized assessment, whether a device uses a fixed code, a rolling code or only a CRC.

Architecture

  1. CC1101 module

    A sub-GHz radio front end with a modem, packet engine and antenna connection.

  2. Microcontroller over SPI

    Your board sets frequency, modulation and packet options, then reads or writes bytes.

  3. Your application

    Turns those bytes into a sensor reading, a remote command, a log entry or a test result.

The module moves bytes. The microcontroller and your firmware decide what they mean.

Implementation

  • An ESP-IDF C component targets the CC1101 on an ESP32-S3, with SPI configuration for frequency, modulation and packet options.
  • Framed packet transmission and reception are separate from raw demodulator capture. The raw path captures digital pulse timing, not I/Q samples.

Security takeaways

  • A valid CRC detects transmission errors. It does not prove who sent a frame or stop a replay; authentication belongs in the protocol.
  • Only transmit on hardware and frequencies you own or are authorized to test, within your region's power and duty-cycle limits.

Scope and limitations

This is a research driver and console, not a certified radio product, and it is not an SDR or an arbitrary-protocol decoder. Performance and range are not claimed here; the README separates earlier hardware runs from later source changes.

Source references

Source review:

  • PythonSecurity

    modbus

    Python Modbus CLI for reading, watching and testing industrial devices over network and serial transports, with a built-in simulator.

    Updated Source on GitHub

  • PythonNetworks

    RTSP_TO_HTTP

    HiveHack @ CyberSea challenge pipeline: find an RTSP camera, convert the stream to HLS with FFmpeg and play it over HTTP in a smart TV browser.

    Updated Source on GitHub

7SOULSeven Inch Soul